Staenis Layout Planning Tool - beta version

Design your custom space in 2 steps: draw walls, choose the layout, and choose the anchor position.

Step 1: Drawing walls

Click to place corner points. Close the space by clicking the first point.

Draw at 90° Tip: The grid filling doesn't always work optimally on slanted walls. Preferably use right angles where possible.

Step 2: Choose filling and anchor

After "Walls finished," an initial filling is calculated. Then, use the slider to select an anchor position, ranging from economical to less economical.

Screed (wet mortars) Dry floor with OSB

Anchor position (optimized options)

Min. pieces Not yet calculated Max. pieces

Status

Active step: 1 - Drawing walls

Surface area: — m²

Number of legs: 0

Number of slats (order): 0

Note: at wall connections with shortened slats, the inner support legs are now also provided so that the parallel edge slat effectively remains clip-in; exact cutting against the walls may still vary.

Required grid boxes

Based on the calculated slats and legs.

20 m² screed grid

x 0

(0 × 160 latten + 100 poten)

10 m² screed grid

x 0

(0 × 80 latten + 50 poten)

5 m² screed grid

x 0

(0 × 40 latten + 25 poten)

+Extra legs (25 pieces) - Extra edge support for OSB support

x 0

+Extra slats (8 pieces) - Extra edge support for OSB support

x 0

Staenis Layout Planning Tool - beta version

Required grid boxes

What our customers say