How many pieces of staenis slats and staenis legs do I need?

The average number of pieces depends on the chosen filler and grid:

- For screed, stabilized screed, insulating screed, drainage mortar and screed grid, you need an average of 8 battens and 5 legs per square meter.

- For load-bearing fillers and with the fibre-reinforced drying floor grid: you generally need 8 slats and 5 legs per square metre.

- For non-load-bearing fillers (such as glass wool, cork granules, EPS beads or no filler) and with the fibre-reinforced drying floor grid: you need a minimum of 8 slats and 5 legs per square metre (more corner connections result in higher consumption).

For non-load-bearing fillers, you can also replace the fiber-reinforced dry floor grating with the screed grating, but because this screed grating is less load-bearing, you will need to add 8 additional yellow legs per square meter (a total of 13 yellow legs and 8 slats per square meter).

In case of doubt or extremely heavy loads, we recommend providing additional legs or reinforcing the legs (for example with cement or lime mortar).

For the fibre-reinforced drying floor grid -> Use the yellow screed extension legs to adjust the height from 9 to 13 cm without loss of load-bearing capacity.

Always round up when ordering to ensure you don't run out of stock during installation.